Purtrex

Description
The Purtrex depth filter, is an exceptional value for general applications where long life, high purity and low change-out frequency are required. Produced through GE’s patented melt blown microfiber technology.

Purtrex is a 100% pure polypropylene depth filter.
Exceptional dirt-holding capacity.
Purtrex’ true-graded density filter matrix (lower density at the surface of the filter with progressively higher density toward the center) captures particles throughout the entire filter depth.
Fewer change-outs than existing string-wound or resin-bonded filters.
No wetting agents, solvents, antistatic agents or binders.
Meets the requirements of the FDA for food and beverage contact.
Incinerates to trace ash for easy disposal.

Typical Applications

Potable water filtration
Chemical filtration - wide chemical compatibility
Plating baths
Amine Filtration
Food and Beverages

For a Complete Product Data Sheet on this product CLICK here
*Trademark of General Electric Company; may be registered in one or more countries.
©2008, General Electric Company. All rights reserved

Should you not find results for the specific filter you build below let us know as we can usually get it.
CustomerCare@Filters.com

NOTE: For no endcaps, don't select end adapters or gasket material options below.

Micron Rating	Cartridge Length	End 1 Adapter	End 2 Adapter	Gasket Material

Important Ordering Information
If you are ordering Hytrex Filters with standard ends (with no adapter on either end), select one designation
from each of the first three columns. Your Product Order Number will look like this: PX01-10. If you
are ordering Hytrex Filters with end adapters, select designations from all applicable columns. Your Product
Order Number will look like this: PX01-20-EHS.